1967 Kaiser M715

Serial Number :13333

PPG Matt Pepper & Cyber Gray

LS1/SM465/NP205, Twin Sticked, Custom Dana 60 Front/Dana 70 Rear, 4.56 gears w/ Detroit Locker, Four Wheel Disk

  • Paint

      • PPG Pepper Gray - Code: 931611

      • PPG Cyber Gray - Code: 920131

      • PPG Matt Clearcoat = Code D8115

  • Engine

      • Corvette 5.7 LS1

      • Block Hugging Center Drop Headers.

          • NOTE: Required to clear manual clutch linkage and a ton of other stuff on driver side. Long Tubes WILL NOT work.

      • Summit Racing Crossflow Radiator & Dual Spal Kit - Part#: SUM-3844012-KIT1

          • 1,300-1399 cfm

      • Steam Vent Solution

          • Fragola MPT Fitting - Part#: 484004-BL

            • Installed in top radiator hose

          • Mishimoto Water Temp Sensor Adaptor - Part#: MMWHS-28-BK

      • LS1 Truck Oil Pan - Part#: WND-5042WND

  • Fuel Delivery

      • Spradlin Bros. Welding, Columbus OH, Custom Stainless Steel Gas Tank w/ Straps

      • Classic Tube Stainless Steel Fuel Lines - Part#: JEF1014-SS

      • In-tank Pump

  • Drivetrain

      • Standard SBC Manual Bellhousing

      • LS7 Pilot Bearing to compensate for the LS1 crank offset - Part#: 12557583

      • 12" Clutch Kit, 10-spline, 1 1/8" input shaft, w/ throwout - Part#: LUK 04-064

      • Standard LS flywheel - Part#: Sachs NFW 1050

      • GM SM465 Manual 4-speed Transmission

      • GM NP205 Passenger Drop Married Transfer Case

      • JB Custom Fabrication Transfercase Shifters & Rails

          • Part#: SR205GM

          • Part#: BUGFM205GM

      • High Angle Driveline Transfercase Ebrake - Part#: 205EB

      • Custom 1 ton Drive Shafts

      • Custom Hillbilly Wizard CUCV Axles, WMS to WMS set at 77"

          • Dana 60 Front

          • Dana 70 Rear

          • 4.56 Gears

          • 4 Wheel Disk

          • Detroit Locker

          • Trail-Gear Creeper Breather - Differential Breather Kit - Part#: 140207-1-KIT

  • 24V -> 12V Conversion

      • Vintage Wiring of Maine stock reproduction body harness - Part#: VINT000873

      • Swapped out early model analog turn signal box for late model solid state.

          • Military Vehicle 24V turn signal control - Part#: 11613632-3

          • Harness & Flasher - Part#: 11613631

          • Standard Warner 12v bulbs. Will replace with LED soon.

          • NOTE: Box Swap Required for 12V turn signals.

      • Holly TerminatorX ECU & engine harness - Part#: HLY-550-929

      • Drive by Wire GM Gas Pedal

  • Body

      • Novak Engine Mounts - Part#: MMX-WG3

      • Custom BJ's Offroad Crawler Front Bumper

          • Part#: 25-1000-25-1001

          • Part#: 25-1001-FM

          • Part#: 25-1002-25-1004

      • Warn ZEON 12 Winch - Part#: 89120

      • Custom BJ's Offroad Rock Rails/Steps, Evil Twin Fab - Part#: 05-2663

      • Rugged Ridge Hood Catches - Part#: 11210.15

      • Raptor Lining Bed Liner Cab & Bed - Part#: UP0820

      • UPOL Gravitex Under Body Coating - Part#: UP0721

      • AU-VE-CO Products Door Weatherstrip - Part#: 16891

      • Robin Rielly Fiberglass Reproduction Gladiator Rino Grill

      • 1980s Grand Wagoneer Hood bar w/ additional hood pin. Required at highway speeds to prevent hood cracking.

      • The Upholstery Man, Inc. Daytona FL, Modern Fabric Reproduction Convertible Top

  • Interior

      • New Vintage Gauges 1940 Series - Part#: 40614-03

      • ‎Mfm Building Product Peel & Seal Self Stick Roll Roofing, Aluminum foil rubberized asphalt waterproof sheeting - Part#: 50036

      • StockInteriors Carpet - Part#: 9296

      • FSJ Foot Well Vents w/ Aircraft Spruce Control Cables, Plain Dural Knob Control 8' - Part #: 05-14300

      • The Upholstery Man, Inc. Daytona FL, Custom Rear Cab Wall Insulation Plate

      • Lane Dickey Upholstery, Longwood FL, 1977 Folding Jeep Truck Bench Seat

      • BJ's Offroad AC - Part#: 07-8072

      • Al Temple Reproduction Sill Plates

      • 1973-1987 GM SM465 Chrome Shifter for K30,K10 Square Body

  • Steering

      • Grant Steering Wheel & Adapter w/ 1960's Gladiator Horn Button (customized to fit)

          • Part#: 4403

          • Part#: 410414

      • Borgeson Heavy Duty Telescopic Stainless Steel Steering Shaft

          • Part#: 450024

          • Part#: 014940

          • Part#: 014952

          • NOTE: The stock column shaft will have to be ground to 3/4" DD

      • BJ's Offroad Read Head Steering Box

      • BJ's Offroad Read Head Pitman Arm

      • Skyjacker Dual Steering Stabilizers

          • Stabilizers - Part#: SJA-9220

          • Rugged Ridge Stabilizer Bracket - Part#: 18040.50

          • TeraFlex Stabilizer Bracket - Part#: 1510000

  • Wheels, Braking & Suspension

      • Trailworthy Fabrication HMMWV 24 Bolt Wheels w/ Run Flat - Double Bead Lock Inserts - Part#: WHL-24BT1

      • Centromatic Front Axle Wheel Balancers - Part#: 400-408

      • Rancho RS9000XL Shock Absorbers

          • Part#: RS999001

          • Part#: RS999338

      • BJ's Offroad Hydroboost - Part#: 3096-6366

      • Adjustable Proportional Valve

  • Other Stuff

      • RockLaurence Custom 2" Trailer Hitch, need to request 44" frame width

      • EMP Shield Electrical System Pulse protection - Part#: DC-12V-W

      • Custom Magnaflow Dual Exhaust

      • Key Fob Battery Kill

  • Contact Info

HUGE shout out to Dave Clark, crowtowncustomz@att.net and Dave Clark • Instagram for making this happen! Dave is a heck of a guy. Highly skilled, talented, and trustworthy. And his boss @ Jeff's Restoration in Holly Hill, FL for ALLOWING it to happen. They both got into more than they bargained for but never complained a bit. Beautiful work.

THANK YOU !!!